Tools Required
Step 1
During consultation, it is vital that you understand the client’s requirements. Always check the condition of the hair and scalp during client consultation, examine the hair texture, type and volume.
Tip
Look out for any skin conditions like eczema or psoriasis. Any lumps, moles, cuts or abrasions may also limit the services available to the client. Ask the client if they are aware of any such conditions.
Step 2
Once the consultation is completed, the stylist can then make suitable recommendations.
Perform the service only if you do not find any contraindications.
For a wet cut, first shampoo the client’s hair.
Step 3
Divide the hair into a ‘horseshoe section’.
Cleanly secure the top section and sides away.
Start the cut at the centre back in the underneath section, pulling the hair out from the head holding fingers at a 450 angle. This section will determine the length of the cut.
Pivoting from the centre, point work out towards the ears.
Step 4
At the point behind the ear, change the angle of the sections from vertical to slightly diagonal and begin to over-direct, reducing elevation.
Continue this procedure into the front of the side sections, decreasing elevation and increasing over- direction.
Step 5
Use the crown area as a pivot and connect the top sections into the underneath using the same process of over-direction and increased elevation.
Complete the short graduation cut, then finish the look with a blow dry, using products to achieve our client’s desired style.
Finally, check that the client is happy with their new style and offer to make adjustments, if needed.
Tip
Remember to provide aftercare advice on the best products, how to maintain their style at home and the ideal time interval until their next visit.